Back

Rise Underfloor Heating Fitting Guide

Share
Rise underfloor heating matting is an affordable way to add electric heating under your floor tiles. The heating cable comes fixed to a self-adhesive mat that rolls straight out across the floor, and you control it with the Rise Programmable Thermostat. Below, we’ll talk you through preparing the floor, laying the matting and getting your thermostat fitted, and there’s a video showing you how to install the matting too.
Rise Underfloor Heating Matting System
Rise matting has an output of 150W per m² and is designed to go under ceramic, porcelain and natural stone tiles, either as your main heating or as a secondary heat source. Each mat is 0.5m wide and around 3mm thick, with the heating cable fixed to a self-adhesive fibreglass mesh at 80mm spacing. The cable is a 3.5mm multistrand, twin core, double insulated cable with a 2.5m cold tail.
Heated Area Mat Length Power Load
1.5m² 3m 225W 0.98A
2m² 4m 300W 1.30A
3m² 6m 450W 1.96A
4m² 8m 600W 2.61A
10m² 20m 1500W 6.52A
15m² 30m 2250W 9.78A
Choosing The Right Size
Measure the area you want to heat and pick the mat that fits it, taking your time with the measuring, as the heating cable can’t be cut. Rise matting rolls out easily across larger or open spaces and can be used in any room of the home.
Preparing The Floor
You can lay Rise matting over concrete, cement screed, anhydrite and timber subfloors, as long as the floor has been prepared to the manufacturer’s guidelines. We recommend using a suitable tile backboard, such as our Warmup insulation boards, to get the most energy efficient results from your heating, and building the floor up in this order:

  1. Subfloor
  2. Flexible tile adhesive
  3. Insulation boards
  4. Rise matting
  5. Flexible tile adhesive or levelling compound
  6. Floor tiles
Laying The Matting
  1. Roll the matting out with the heating cable facing up, and press the self-adhesive mesh down to fix it securely in place.

  2. When you reach the end of a run, cut the mesh but not the cable, then turn it 180 degrees and continue laying it in the opposite direction.
Covering And Tiling
Once the matting is down, we’d recommend applying a thin layer of flexible levelling compound over it using the flat edge of a trowel, although you can also tile straight over the matting with a flexible tile adhesive. Your electrician can then connect the system before you start tiling, and if you’ve used levelling compound, wait until it’s dry before the tiles go down. Our guide to tiling over underfloor heating goes into more detail.
The Rise Programmable Thermostat
The Rise Programmable Thermostat lets you set your own heating schedule for each day of the week, and it has a holiday mode, open window detection and frost protection too. Its adaptive start feature learns how long your floor takes to heat up, so it can warm it at the right time for you.

It works with both electric and water underfloor heating, has a maximum load of 16A (3680W) and comes with a 3m floor probe, which can be extended if you need it. A 50mm back box is recommended, with 35mm as the minimum, and the thermostat should be fitted away from direct heat sources and outside the bathroom. It should always be installed by a qualified electrician.
Switching The Heating On
Once the floor is tiled, leave the heating off for at least two weeks so the tile adhesive can fully cure. After that, increase the temperature by 1°C a day until it reaches the temperature you want.
You can shop the full Rise underfloor heating range online and in store now, along with our full underfloor heating range. 
Knowledge BaseUnderfloor HeatingRise Underfloor HeatingRise Underfloor Heating Fitting Guide