With highly textured surfaces the use of BAL Protective Sealer may be required. Please ask in store for more details.

Once tiles have been fitted all residues must be removed from the surface of the tile, it is important to use the correct cleaner for this.

Initial Clean (Within 30 minutes of grouting)
For removal of cementitious residues within 10-30 minutes of grouting use Fila Instant Grout Remover

Directions for use: After grouting, wait approximately 10-30 minutes (see manufacturer's instructions) until grout has thickened and become opaque. Carry out an initial clean of the tile surface with a damp sponge. Spray Fila Instant Grout Remover evenly over the surface and leave for 2 minutes. Clean using a damp sponge.
For stubborn stains, leave for 1 hour and repeat the above steps

Initial Clean (After 30 minutes of grouting)
For removal of cementitious residues after 30 minutes of grouting use Fila Porcelain Cement Residue Remover

Directions for use: Dilute 1:5 with clean water and spread the solution over the tiles with a cloth. Leave to act for 5 minutes. Use a green emulsifying pad and work the solution over the surface. Clean up the residue and rinse thoroughly with plenty of clean water.
A second application maybe necessary to remove any existing residue.

This product should not be used neat as the dilution with water activates the ingredients of the cleaner.

For removal of epoxy residues use Fila Multi Surface Stain Remover

Directions for use: Apply Fila Multi Surface Stain Remover undiluted to the surface of the tiles with a cloth. Leave to act for 20 minutes then using an abrasive sponge work the solution over the surface. Clean up the residue and rinse with plenty of clean water.

Do not use on polished Natural Stone, Wood, Acrylic or Plastic surfaces.

Routine Maintenance
It is important to regularly maintain the surface of your tiles to prevent the build-up of deposits, to do this use our pH neutral Fila Multi Surface Cleaner.

Directions for use: Dilute 2 capfuls in to 4 litres of clean water. Apply to the surface and leave to dry; no need to rinse. Covers 100m2 of wall or floor surfaces.

To maintain the life of your grout use Fila Grout Sealer

Directions for use: Once grout is completely dry apply the product directly to the grout joint, if using the spray hold the bottle approximately 10-15cm away from the surface area.
Working in small areas (1m2), use a sponge or brush to aid the products penetration over the grout lines. Remove any excess product or smears from the tiles within a 5 minute period using a clean cloth or kitchen roll. Any Fila Grout Sealer residues that were not removed during application can be removed with Fila Multi Surface Cleaner.

Acidic or highly alkaline cleaners are NOT recommended for the regular maintenance of this tile.

Inspiration & Advice

Trending Now

Summary

Adalene™ Cognac Tile

Colour: Cognac

We think you may also like